fbpx
Print this page
Tuesday, 23 July 2019 10:13

Watch, crack down on scours

Written by 

Scours is a nasty disease to watch for in calves.

There are two types of scours: nutritional and infectious. 

Nutritional scours occurs when unclotted milk enters a calf’s small intestine due to stress, overfeeding or poor quality milk or milk replacer. 

To prevent nutritional scours do not overfeed calves. Make diet changes slowly and use good quality milk/milk replacers.

Feed calves at the same time each day and by the same person. Consistency is the key to reducing stress. 

Infectious scours can be caused by bacteria (E-Coli and salmonella), protozoa (coccidiosis and cryptosporidia) and viruses (coronavirus and rotavirus). 

Consult your veterinarian when calves start scouring. The vet will have the scours diagnosed by laboratory analysis, rather than by scour colour, so that scours can be treated promptly and effectively. 

The first treatment for both types of scours is similar. Remove calves from milk and feed them electrolytes. These will provide the calf with energy and water and replace body salts lost via scouring. 

Provide calves eight litres of electrolyte daily in several small feeds. During scouring, calves may die from dehydration and lack of energy, but not from the scours themselves. 

During serious infectious scours the vet may need to prescribe medication extra to electrolytes. 

Coccidiosis, another prevalent disease, is caused by protozoa that destroy the finger-like villi in the small intestine that absorb nutrients. 

The worst cases of coccidiosis will have bloody scours, but most calves won’t have any visible signs, they will just grow more slowly. 

Calves going onto grass should be on clean pasture to keep their worm burden low. 

De-worm them every three to four weeks from weaning to winter. 

It is cheaper and easier to prevent disease than cure it, so biosecurity and hygiene are important.

Control the flow of people in and around the calf barn and only allow access to essential people. Keep visitors away from calf barns. 

Have dedicated equipment for the calf barn and ensure that it is kept clean. This includes wearing clean clothing and boots. 

Always wash hands with soap and warm water before and after handling calves, feed and feeding equipment. 

Keep sick calves in a separate pen away from the others. Keep handy a safe, quality virucidal spray. 

Locate the calf barn away from cows and dairy effluent. Cows can carry disease, and calves do not have the fully developed immune system of a cow so they will get sick more readily than cows.

• Source: CRT Calf Rearing Guide

More like this

Harness the power of the rumen

Dairy farmers have the perfect tool at their disposal this calving season to set their herds up for future productivity – the rumen in their replacement heifer calves.

Explore calving conditions when winter grazing

Planning to calve in the right conditions is essential for cow and calf health. Avoid calving in muddy conditions to decrease the risk of death and infections for both the cow and the calf.

Featured

NZ growers lead freshwater compliance

Horticulture New Zealand (HortNZ) says that commercial fruit and vegetable growers are getting ahead of freshwater farm plan regulations through its Growing Change project.

Case IH partners with Meet the Need

Tractor manufacturer and distributor Case IH has announced a new partnership with Meet the Need, the grassroots, farmer-led charity working to tackle food insecurity across New Zealand one meal at a time.

25 years on - where are they now?

To celebrate 25 years of the Hugh Williams Memorial Scholarship, Ravensdown caught up with past recipients to see where their careers have taken them, and what the future holds for the industry.

National

Top ag scientist to advise PM

A highly experienced agricultural scientist with specialist knowledge of the dairy sector is the Prime Minister's new Chief Science Advisor.

Machinery & Products

Hose runner saves time and effort

Rakaia-based equipment manufacturer Pluck’s Engineering will soon start production of a new machine designed to simplify the deployment and retrieval…